gangklion.blogg.se - Reflector sticks

#Reflector sticks free

Hand washing the application area with soap and water will accomplish this.Īlso, to insure that the area is clean, a cloth soaked in isopropol alcohol can be used to wipe the surface down.

#Reflector sticks free

The surface that the tape will be placed on needs to be clean, dry and free of any contaminants such as dirt, grease, oil, etc. Also, it helps to apply a small piece first as practice. Air temperature should be between 32 and 100 degrees. Do not apply in the rain or moist environments. The surface should be clean and dry and it should be dry outside. Instructions for Applying Reflective Tapes (see special instructions for this tape at the bottom of this page) The recommended temperature for applying is 59 – 77 degrees. (after installation the temperature does not affect it) When the tape is cold it is stiff. Fourth, when installing “Flexible Engineer Grade Tape” keep in mind that it is temperature sensitive during installation.Once installed, the tape needs to cure for at least 48 hours before it is subjected to sub zero temperatures.

Third, do not apply tape in freezing weather or allow the tape to freeze.

Otherwise the gases from the curing paint will deteriorate the adhesive and cause the application to fail.

Second, newly painted surfaces should fully cure before tape is applied.

Also, rough surfaces are difficult to apply to because the tape does not touch the entire surface. For example, some plastics are non stick and difficult to apply to.

First, it is up to the installer to determine whether the surface that the tape will be applied to is able to accept adhesive type tapes.

Adhesive performance depends almost entirely on surface preparation.īefore beginning an installation there are a few factors to consider. However, some preparation must be done beforehand to insure a long lasting application. Installing Reflective Tape – ( It is basically a peel, stick and press process.